DAKAI
Applications1 min read

Why thin-wall seamless tube is hard to make: wall deviation, cold rolling and cold drawing

At 1 mm wall, stiffness, cleanliness and inspection margin all shrink at once. How cold rolling, cold drawing and straightening hold OD ±0.75% and wall within 10%.

By Dakai Steel Technical Team

Why thin-wall seamless tube is hard to make: wall deviation, cold rolling and cold drawing

With walls down to 1 mm, thin-wall seamless tube has become a core material for high-end equipment. Each further reduction tests raw material, forming process and inspection at once.

Forming accuracy once stiffness drops

Thinner wall means far less stiffness: cold rolling is prone to flattening, wrinkling and eccentricity, and small drifts in rolling temperature or roll gap turn into uneven wall and oversize. Holding OD deviation within ±0.75% and wall deviation to ≤10% is where conventional routes fail.

Cleanliness: flaws get stretched

Drawing a thin wall magnifies micron-scale inclusions and gas pores in the billet into cracks and pinholes, and the tube is scrapped. The billet must be very clean and structurally uniform.

Straightening and NDT: little margin

A thin wall resists deformation poorly. A slight excess of straightening force dents or twists the tube, so straightness has to be found in a narrow margin. Conventional testing also struggles to resolve fine defects in a thin wall.

Equipment and control across the chain

The mill runs 34 cold-rolling, 7 cold-drawing and 14 straightening units and forms the tube in one seamless piece, OD 6–630 mm, wall 1–50 mm. A joint lab and a CNAS lab cover over 20 checks in chemistry, NDT and dimensions.

What a thin wall buys

Within strength and pressure limits, a thin wall cuts material use, improves heat transfer and simplifies installation and maintenance. It already serves heat exchangers, petrochemicals, power, offshore work, instrumentation and electronics.

Send your size list or drawing. Get a quotation within 24 hours.